Description
Vitara, Grand Vitara, Sidekick, Tracker Body Lift, also fits XL7
2″ Vitara, Grand Vitara, Sidekick, Tracker Body Lift. Looking for some extra boost to your project Sidekick, Tracker, Grand Vitara, XL7, or Vitara?
We’ve got what you need.
- Easy Installation: Bolt on system requires no cutting or fabrication to install.
- High Impact Composite Spacers: High quality spacers which will not distort or fracture over time
- 2″ Lift Height Avoids Problems: Stay below the 3″ problem point with our 2″ kits.
- Unchanged Suspension: Leaves the factory springs, shocks, and suspension geometry untouched.
- No Frame Lift: Does not raise the frame, axles, differentials, or lowest chassis points off the ground. Center of gravity stays lower
- Additional Hardware: Includes specialized hardware mounting components
Forget the hassles and complications associated with a 3″ Sidekick/Tracker body lift. They are too complicated for any mortal do-it-yourselfer to tackle. 3″ kits really mess with your steering and shifter systems. The steering Ujoint with 3″ body lifts often binds up creating potentially dangerous situations. You also end up having to chop up your floor and center console to make room for the shifters since they move so far with 3″ body lifts.
Saving that extra inch by going with a Rocky Road 2″ Sidekick/Tracker body lift saves you a lot of headache which is why we’re so confident you’ll love our 2″ system.
Our simple kit allows you to bolton 2 extra inches in just a couple of hours. Very beefy construction and easy instructions. No drilling or modification to your vehicle is required.
Best Quality & Safest Suzuki/Geo Body Lift
We do recommend moving the bumper brackets up for a nice look and will extend your shifters if you desire at no cost. Our kit also includes the service of extension of your stock shifters should you find this of importance (though few people find it necessary). We just need to have your stock shift levers and will cut and weld the extensions in!
Spacers are made from high impact resistant and UV stable DuPont material. Machined sleeve and nut assembly allows you to just screw each body spacers into place in a minute or two. This kit is not only simple, but very safe as well.
